REAR SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE
Tech Tips
-
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Rear Suspension Crossmember Installation Hole | φ80 (3.15) |
| B, b | Rear Suspension Crossmember Standard Hole | φ15 (0.59) |
| C, c | Rear Suspension Lower Arm No.1 Installation Hole | φ10 (0.39) |
| D, d | Rear Suspension Upper Arm No.1 Installation Hole | φ10 (0.39) |
| E, e | Rear Suspension Upper Arm No.2 Installation Hole | φ10 (0.39) |
| F, f | Rear Suspension Lower Arm No.2 Installation Hole | φ10 (0.39) |
| G, g | Rear Suspension Crossmember Installation Hole | φ80 (3.15) |
| *A | Front | *B | LH |
| *C | RH | - | - |
| *a | mm (in.) |
- | - |
| *A | LH | *B | RH |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm (in.) |
- | - |