FRONT SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE
Tech Tips
-
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A | Front Suspension Crossmember Installation Hole | φ24 (0.94) |
| a | Front Suspension Crossmember Installation Hole | φ28.2X23.7 (1.11X0.93) |
| B, b | Front Suspension Lower Arm Front Installation Hole | φ14 (0.55) |
| C, c | Front Suspension Lower Arm Front Installation Hole | φ14 (0.55) |
| D, d | Power Steering Gear Box Installation Hole | φ15 (0.59) |
| E, e | Front Suspension Lower Arm Rear Installation Hole | φ14 (0.55) |
| F, f | Front Suspension Lower Arm Rear Installation Hole | φ14 (0.55) |
| G, g | Front Suspension Crossmember Installation Hole | φ27 (1.06) |
| *A | Front | *B | LH |
| *C | RH | - | - |
| *a | mm (in.) |
- | - |
| *A | LH | *B | RH |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm (in.) |
- | - |