FRONT SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE
Tech Tips
-
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Power Steering Gear Box Installation Hole | φ14.5 (0.57) |
| B, b | Front Suspension Lower Arm Installation Hole | φ14.5 (0.57) |
| C | Front Suspension Crossmember Installation Hole | φ17.5 (0.69) |
| c | Front Suspension Crossmember Installation Hole | 22X17.5 (0.87X0.69) |
| D, d | Front Suspension Lower Arm Installation Hole | φ14.5 (0.57) |
| E, e | Front Suspension Crossmember Installation Hole | φ23 (0.91) |
| F, f | Front Suspension Lower Arm Installation Hole | φ12.3 (0.48) |
| Front Suspension Member Installation Area | Within +/-2.0 mm (0.08 in.) |
| Upper Arm Bracket Installation Area | Within +/-1.5 mm (0.06 in.) |
| *A | FRONT | *B | LH |
| *C | RH | - | - |
| *a | mm (in.) |
- | - |
| *A | LH | *B | RH |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm (in.) |
- | - |