ROCKER OUTER PANEL CUT AND JOIN REPLACEMENT SECTIONS

A01Q09Y

  1. REMOVAL

    Symbol Meaning
    A01Q0FO Remove Weld Points
    A01Q0M9 Cut and Join Location
    A01Q0KD Cut Location for Supply Parts
    A01Q0M5C01
    *a 115 mm (4.53 in.) - -
    A01Q0I3 Laser Screw Welding - -
    A01Q0C6

    1. When replace only the outer panel, please cut off a necessary range depending on a damage range.


      1. Carefully cut the outer panel so not to damage the reinforcement.

      2. Make sure that butt welding does not heat-affect the reinforcement when welding the outer panel.

  2. INSTALLATION

    Symbol Meaning
    A01Q0J0 Plug Weld
    A01Q0HW Butt Weld

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

      A01Q09WC01
      *1 CENTER BODY PILLAR OUTER - -
      A01Q0I3 Laser Screw Welding - -

    3. After welding, apply body sealer to the corresponding parts. (See the painting/coating)

    4. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.