FRONT SIDE MEMBER ASSEMBLY REPLACEMENT

After removing the A, remove the front side member sub-assembly and floor crossmember subassembly NO.3.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

If the entire supply part is not needed, remove the part of the supply part that is needed.

A is reused.

Before temporarily installing the new parts, weld the front side member sub-assembly and floor crossmember sub-assembly NO.3 with the standard number of welding points.

When welding *a, make a hole on a new part for plug welding and weld the panel with the panel behind completely.

Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.

After welding the front side member sub-assembly and floor crossmember sub-assembly NO.3 to the vehicle side, install the B.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.