QUARTER PANEL END HOUSING ASSEMBLY REPLACEMENT

A00256O


  1. REMOVAL

    Symbol Meaning
    A002563 Remove Weld Points
    A00257N Remove Weld Points
    A0025AX Remove Weld Points

      REMOVAL POINT

    1. *a in illustration indicates where the adhesive is located.

    2. Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

      Tech Tips

      In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.

    A0025A6N01

  2. INSTALLATION

    Symbol Meaning
    A0025D7 Plug Weld
    A0025AO Plug Weld
    A0025EP Plug Weld

      INSTALLATION POINT

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. When welding *a, make a hole on a new part for plug welding and weld the panel with the panel behind completely.

    4. Apply adhesive (3MTMAutomixTMPanel Bonding Adhesive #8115) to the area indicated by *b in the illustration.

      Tech Tips


      • Apply a light coat of adhesive around the plug welding points.

      • Apply enough adhesive to the panels.

    5. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    6. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A0025I8C01
    *1 QUARTER PANEL REINFORCEMENT SUB-ASSEMBLY INNER - -