REAR SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE

Tech Tips


  • Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

  • In cases in which only one dimension is given, left and right are symmetrical.

  • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

Symbol Name

Hole Diameter

mm (in.)

A, a Rear Suspension Crossmember Installation Hole φ72.2 (2.84)
B, b Rear Suspension Crossmember Standard Hole φ15 (0.59)
C, c Rear Suspension Lower Arm No.1 Installation Hole φ12.2 (0.48)
D, d Rear Suspension Upper Arm No.1 Installation Hole φ14.2 (0.56)
E, e Rear Suspension Upper Arm No.2 Installation Hole φ14.2 (0.56)
F, f Rear Suspension Lower Arm No.2 Installation Hole φ14.2 (0.56)
G, g Rear Suspension Crossmember Installation Hole φ82 (3.23)
Tolerance
Rear Suspension Member Installation Area Within +/-1.5 mm (0.059 in.)
Each Linkage Arm Installation Area Within +/-1.5 mm (0.059 in.)
A001ZUYC01
*A FRONT *B LH
*C RH - -
*a

mm

(in.)

- -
A00205LC01
*A LH *B RH
*a Imaginary Datum Line *b Height from Imaginary Datum Line
*c

mm

(in.)

- -