ROOF PANEL (for Sliding Roof) ASSEMBLY REPLACEMENT

A00YIPL

  1. REMOVAL

    Symbol Meaning
    A00YIJD Remove Weld Points
    A00YIL3 Remove Weld Points
    A00YIR8E01

  2. INSTALLATION

    Symbol Meaning
    A00YIO1 Spot Weld
    A00YIJ3 Plug Weld
    A00YIJQ Plug Weld
    A00YIM6 Body Sealer

      INSTALLATION POINT

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. Before temporarily installing the new parts, apply body sealer to the roof panel reinforcement and back door opening frame.

      Tech Tips

      Apply just enough body sealer for the new parts to make contact.

    4. After the roof panel reinforcement is welded to the new parts, install the roof panel rear to the vehicle side.

    5. Bend the flange hem with a wooden hammer and dolly.

      Tech Tips

      Perform hemming three steps, being careful not to warp the panel.

    6. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    7. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A00YIN6E01
    A00YINBE01