REAR SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE


  1. for Double Wishbone Type Suspension

    Tech Tips


    • Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

    • In cases in which only one dimension is given, left and right are symmetrical.

    • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

    Measuring Point Name
    Symbol Name

    Hole Diameter

    mm (in.)
    A, a Rear Suspension Member Installation Hole φ55.2 (2.17)
    B, b Lower Control Arm Installation Hole

    24.1X15.2

    (0.95X0.60)
    C, c Stabilizer Installation Hole φ15 (0.59)
    D, d Lower Control Arm Installation Hole φ7 (0.28)
    E, e Rear Suspension Member Installation Hole φ67.6 (2.66)
    A0031G6C01
    *A Front *B LH
    *C RH - -
    *a

    mm

    (in.)

    		 - -
    A0031SQC01
    *A LH *B RH
    *a Imaginary Datum Line *b Height from Imaginary Datum Line
    *c

    mm

    (in.)

    		 - -