ROCKER REAR PANEL CUT AND JOIN REPLACEMENT SECTIONS



  1. REMOVAL

    Symbol meaning
    A01IVLP Remove Weld Points
    A01IVNA Cut with Disc Sander etc.
    A01IVT6 Cut Location for Supply Parts

      REMOVAL POINT

    1. *1 is reused.

    A01IVT1E01

  2. INSTALLATION

    Symbol meaning
    A01IVM8 Plug Weld
    A01IVUV Plug Weld
    A01IVMT Butt Weld
    A01IVLT Body Sealer

      INSTALLATION POINT (for TMC, TMMR Made)

    1. If the entire supply part is not needed, remove the part of the supply part that is needed.

    2. Before temporarily installing the new parts, weld the center body pillar reinforce lower, rocker extension outer and rocker panel reinforcement with the standard number of welding points.

    3. After welding the center body pillar reinforce lower, rocker extension outer and rocker panel reinforcement to the vehicle side, install the *1.

    4. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


      INSTALLATION POINT ( for TMMK Made)

    1. If the entire supply part is not needed, remove the part of the supply part that is needed.

    2. Before temporarily installing the new parts, weld the center body pillar reinforce lower and rocker reinforce outer with the standard number of welding points.

    3. After welding the center body pillar reinforce lower and rocker reinforce outer to the vehicle side, install the *1.

    4. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A01IVLHE02
    A01IVL0E01
    A01IVVLE01