CENTER BODY PILLAR CUT AND JOIN REPLACEMENT SECTIONS

A01IVUQ

  1. REMOVAL

    Symbol meaning
    A01IVLP Remove Weld Points
    A01IVN5 Cut with Disk Sander etc.
    A01IVNA Cut and Join Location
    A01IVT6 Cut Location for Supply Parts

      REMOVAL POINT

    1. *1 is reused.

    A01IVOQE02
    A01IVNIE02

  2. INSTALLATION

    Symbol meaning
    A01IVM8 Plug Weld
    A01IVNA Cut and Join Location
    A01IVMT Butt Weld

      INSTALLATION POINT

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. If the entire supply part is not needed, remove the part of the supply part that is needed.

    4. Before temporarily installing the new parts, weld the center body pillar reinforce upper and center body pillar inner with the standard number of welding points.

    5. After welding the center body pillar reinforce upper and center body pillar inner to the vehicle side, install the rocker panel outer and *1.

    6. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)

    7. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A01IVM1E02
    A01IVOKE02
    A01IVTGE02
    A01IVNCE02
    A01IVUEE02
    A01IVVVE02