REAR SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE


  1. for TMC, TMMR Made

    Tech Tips


    • Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

    • In cases in which only one dimension is given, left and right are symmetrical.

    • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

    Measuring Point Name
    Symbol Name

    Hole Diameter

    mm (in.)
    A, a Rear Suspension Member Installation Hole φ49.7 (1.96)
    B, b Rear Suspension Lower Arm Installation Hole φ16 (0.63)
    C, c Rear Suspension Member Standard Hole φ15 (0.59)
    D, d Rear Suspension Member Installation Hole φ49.7 (1.96)
    E, e Rear Suspension Lower Arm Installation Hole φ16 (0.63)
    A01IVK5E03
    A01IVPWE03

  2. for TMMK Made

    Tech Tips


    • Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

    • In cases in which only one dimension is given, left and right are symmetrical.


    • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

    Measuring Point Name
    Symbol Name

    Hole Diameter

    mm (in.)
    A, a Rear Suspension Member Installation Hole φ49.7 (1.96)
    B, b Rear Suspension Lower Arm Installation Hole φ16 (0.63)
    C, c Rear Suspension Member Standard Hole φ15 (0.59)
    D, d Rear Suspension Member Installation Hole φ49.7 (1.96)
    E, e Rear Suspension Lower Arm Installation Hole φ16 (0.63)
    A01IVPPE03
    A01IVQCE02