FRONT SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE


  1. for TMC, TMMR Made

    Tech Tips


    • Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

    • In cases in which only one dimension is given, left and right are symmetrical.

    • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

    Measuring Point Name
    Symbol Name

    Hole Diameter

    mm (in.)
    A, a Front Frame Standard Hole φ13 (0.51)
    B, b Front Frame Installation Hole φ62 (2.44)
    C, c Front Frame Standard Hole φ13 (0.51)
    D, d Front Frame Standard Hole φ13 (0.51)
    E, e Front Frame Standard Hole φ13 (0.51)
    F, f Front Suspension Lower Arm Installation Hole φ15 (0.59)
    G, g Front Frame Installation Hole φ67.5 (2.66)
    A01IVUTE03
    A01IVQ7E06

  2. for TMMK Made

    Tech Tips


    • Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

    • In cases in which only one dimension is given, left and right are symmetrical.

    • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

    Measuring Point Name
    Symbol Name

    Hole Diameter

    mm (in.)
    A, a Front Frame Standard Hole φ13 (0.51)
    B, b Front Frame Installation Hole φ62 (2.44)
    C, c Front Frame Standard Hole φ13 (0.51)
    D, d Front Frame Standard Hole φ13 (0.51)
    E, e Front Frame Standard Hole φ13 (0.51)
    F, f Front Suspension Lower Arm Installation Hole φ15 (0.59)
    G, g Front Frame Installation Hole φ67.5 (2.66)
    A01IVSGE01
    A01IVMLE01