ROCKER PANEL CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)

A002KAX

  1. REMOVAL

    Symbol Meaning
    A002KEA Remove Weld Points
    A002KDT Cut and Join Location
    A002KCG Cut Location for Supply Parts

      REMOVAL POINT

    1. *a indicates the location of the foamed sealing material. Be careful when cutting as the foamed sealing material is located near the cutting position.

    2. Carefully cut the rocker outer reinforce so not to damage *b.

    A002KHDC01
    *c mm (in.) - -

  2. INSTALLATION

    Symbol Meaning
    A002KEA Remove Weld Points
    A002KAM Spot Weld
    A002KAA Plug Weld
    A002KDT Cut and Join Location
    A002KBL Butt Weld

      INSTALLATION POINT

    1. If the entire supply part is not needed, remove the part of the supply part that is needed.

    2. Carefully cut the rocker outer reinforce so not to damage *a and *b.

    3. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    4. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    5. *c indicates the location of the foamed sealing material. Be careful when welding as the foamed sealing material is located near the area that is cut and joined together.

    6. After welding the rocker outer reinforce to the vehicle side, install the center body outer pillar.

    7. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    8. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A002KHHC01
    *1 Rocker Outer Reinforce - -
    *d mm (in.) - -
    A002KBVC01
    *1 Rocker Outer Reinforce *2 Center Body Outer Pillar