ROCKER FRONT PANEL CUT AND JOIN REPLACEMENT SECTIONS

A003Q5Z

  1. REMOVAL

    Symbol meaning
    A003QEL Remove Weld Points
    A003Q4Z Remove Weld Points
    A003QCY Remove Weld Points
    A003Q6O Cut with Disc Sander etc.
    A003Q7Y Cut and Join Location

      REMOVAL POINT

    1. *1 is reused.

    2. *2 in illustration indicates where the adhesive is located.

    3. Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

      Tech Tips

      In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.

    4. Carefully cut the rocker panel sub-assembly outer so not to damage *3.

    A003Q8ME01
    A003Q77E01

  2. INSTALLATION

    Symbol meaning
    A003QEL Remove Weld Points
    A003QAT Spot Weld
    A003Q8E Plug Weld
    A003Q9J Plug Weld
    A003QDJ Plug Weld
    A003Q7Y Cut and Join Location
    A003QBS Fillet Weld
    A003Q60 Butt Weld

      INSTALLATION POINT

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. If the entire supply part is not needed, remove the part of the supply part that is needed.

    4. *1 is reused.

    5. Carefully cut the rocker panel sub-assembly outer so not to damage *2.

    6. When welding *3, make a hole on a new part for plug welding and weld the panel with the panel behind completely.

    7. Apply adhesive (3MTMAutomixTM Panel Bonding Adhesive #8115) to the area indicated by *4 in the illustration.

      Tech Tips


      • Apply a light coat of adhesive around the plug welding points.

      • Apply enough adhesive to the panels.

    8. After welding the rocker panel sub-assembly outer and *5 to the vehicle side, install the *6.

    9. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    10. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A003QBNE01
    A003Q82E01
    A003QBWE01