LUGGAGE DOOR THREE-DIMENSIONAL DISTANCE

Tech Tips


  • Point G, g on the vehicle are asymmetrical.

  • In cases in which only one dimension is given, left and right are symmetrical.

  • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

Measuring Point Name
Symbol Name

Hole Diameter

mm (in.)
A, a Roof Panel Corner -
B, b Quarter Panel Standard Hole

12X10.5

(0.47X0.41)
C Upper Back Panel Reinforcement Center Mark -
D, d Quarter Inner Panel Rear Extension Corner -
E, e Quarter Panel Standard Hole φ13 (0.51)
F, f Rear Floor Finish Plate Installation Hole φ8.5 (0.34)
G, g Luggage Compartment Door Lock Striker Installation Nut M6 (0.24)
H, h Rear Floor Side Rear Member Standard Hole φ18 (0.71)
J, j Rear Floor Side Rear Member Standard Hole φ18 (0.71)
K, k Rear Spring Support Hole φ13 (0.51)
L, l Center Body Pillar Assembly Mark -
M, m Millimeter Wave Radar Rear Sensor Installation Bolt M6 (0.24)
n Millimeter Wave Radar Rear Sensor Installation Bolt M6 (0.24)
A003QHME01
*1 Distance between points other than those above
*2 mm (in.)