UNDER BODY(for AWD) THREE-DIMENSIONAL DISTANCE
Tech Tips
-
Point F, f on the vehicle are asymmetrical.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Front Crossmember Standard Hole | φ13 (0.51) |
| B, b | Front Suspension Crossmember Installation Nut | M16 (0.63) |
| C, c | Front Suspension Crossmember Installation Nut | M16 (0.63) |
| D, d | Torque Front Box Standard Hole | φ25 (0.98) |
| E, e | Front Side Member No. 5 Reinforcement Standard Hole | φ18 (0.71) |
| F, f | Engine Rear Mounting Member Installation Nut | M10 (0.39) |
| G, g | Front Floor Under Reinforcement Standard Hole | φ15 (0.59) |
| H, h | Propeller w/ Center Bearing Shaft Installation Nut | M10 (0.39) |
| J, j | Rear Floor Side Member Standard Hole | φ18 (0.71) |
| K, k | Rear Suspension Member Installation Nut | M14 (0.55) |
| L, l | Rear Suspension Member Installation Nut | M14 (0.55) |
| M, m | Exhaust Pipe No. 3 Support Installation Nut | M8 (0.31) |
| *1 | Front |
| *2 | Distance between points other than those to the left |
| *3 | mm (in.) |
| *1 | Front |
| *2 | Distance between points other than those to the left |
| *3 | mm (in.) |