WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED

Refer to the TOYOTA Repair Manual for each inspection procedure.


  1. PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL

    Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
    Necessary Procedure Procedure Details Effect or Inoperative Function when Necessary Procedure is not Performed Notes
    Initialize parking assist monitor system

      Perform either of the following procedures.

    • Fully turn the steering wheel to the right and left.

    • Drive the vehicle at more than 20 km/h (12 mph) for more than 5 minutes on a straight road with as little traffic congestion as possible.

    		 Parking assist function -
    Initialization of power back door system Completely close the back door by hand once. Power back door function Initialization is not necessary if the cable is disconnected and reconnected to the negative (-) battery terminal while the back door is closed. However, the power back door system will not operate if the back door is not unlocked after the cable is reconnected.

    Note

    After the engine switch is turned off, the multi-media module receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least a minute before disconnecting the cable from the negative (-) battery terminal.