NAME PLATE ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    Tech Tips

    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    Note

    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    Tech Tips

    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.

A002L84E02
*a SYMBOL EMBLEM
*b NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE
*c NO. 3 LUGGAGE COMPARTMENT DOOR PLATE
*d Non-reusable part
A002LCGE02
*a BODY SIDE NAME PLATE
*b Non-reusable part

  1. SYMBOL EMBLEM

    A002LDZE01
    Text in Illustration
    *a Location Pin - -

  2. NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE

    A002LADE01
    Text in Illustration
    *a Profile of Luggage Compartment Door Panel - -

  3. NO. 3 LUGGAGE COMPARTMENT DOOR PLATE

    A002L9BE02
    4. Text in Illustration
    *a Profile of Luggage Compartment Door Panel - -

  4. SIDE NAME PLATE

    A002LGME02
    5. Text in Illustration
    *a Profile of Rocker Panel Moulding Assembly - -

Tech Tips

Use the same procedure for the RH side and LH side.