WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED

Refer to the TOYOTA Repair Manual for each work procedure.

1. PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED

   Necessary Procedures	Effect/Inoperative Function when Necessary Procedures not Performed
   Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)
   	Simple intelligent parking assist system*1
   	Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
   	Pre-collision system
   Initialize back door lock	Power door lock control system
   Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2	Stop and start system

   
   

   • *1: When performing learning using the GTS

   • *2: w/ Stop and start system

   Note

   
   

   • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal (for Audio and Visual System).

   • After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal (for Navigation System (for Radio and Display Type)).