CENTER BODY PILLAR(for 5 Door) CUT AND JOIN REPLACEMENT SECTIONS

A003PV9

  1. REMOVAL

    Symbol Meaning
    A0044G9 Remove Weld Points
    A0044D0 Cut and Join Location
    A003PSX Cut Location for Supply Parts

      REMOVAL POINT

    1. *1 is reused.

    A003PYJE03

  2. INSTALLATION

    Symbol Meaning
    A0044GL Plug Weld
    A0044D0 Cut and Join Location
    A0044GJ Butt Weld

      INSTALLATION POINT

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. If the entire supply part is not needed, remove the part of the supply part that is needed.

    4. Carefully cut the center body pillar reinforcement so not to damage *1.

    5. Before temporarily installing the new parts, weld the center body pillar reinforcement and No.1 inner pillar with the standard number of welding points.

    6. After welding the center body pillar reinforcement and No.1 inner pillar to the vehicle side, install the rocker panel outer and *2.

    7. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)

    8. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A003Q2JE02
    A003PYNE02