CENTER BODY PILLAR(for 3 Door) CUT AND JOIN REPLACEMENT SECTIONS



  1. REMOVAL

    Symbol meaning
    A0044G9 Remove Weld Points
    A0044D4 Remove Weld Points
    A0044D0 Cut and Join Location

      REMOVAL POINT

    1. *1 is reused.

    A003PYKE04

  2. INSTALLATION

    Symbol meaning
    A0044GL Plug Weld
    A0044D8 Plug Weld
    A0044D0 Cut and Join Location
    A0044GJ Butt Weld

      INSTALLATION POINT

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. If the entire supply part is not needed, remove the part of the supply part that is needed.

    4. Before temporarily installing the new parts, weld the center body pillar reinforcement and No.1 inner pillar with the standard number of welding points.

    5. After welding the center body pillar reinforcement and No.1 inner pillar to the vehicle side, install the *1.

    6. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)

    7. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A003PXVE01
    A003Q38E01