FRONT SUSPENSION CROSSMEMBER TWO-DIMENSIONAL DISTANCE
Tech Tips
-
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Front Suspension Lower Arm Installation Hole | φ16 (0.63) |
| B, b | Front Suspension Crossmember Installation Hole (Lower) | φ19 (0.75) |
| C, c | Steering Gear Installation Hole | φ14.5 (0.57) |
| D, d | Front Suspension Crossmember Installation Hole (Lower) | φ17 (0.67) |
| *1 | Front |
| *2 | mm |
| *3 | (in.) |
| *1 | Imaginary Datum Line |
| *2 | Height from Imaginary Datum Line |
| *3 | mm |
| *4 | (in.) |