NAME PLATE ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    Tech Tips

    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    Note

    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    Tech Tips

    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.

A01MAS4C01
*1 BACK DOOR NAME PLATE *2 LUGGAGE COMPARTMENT DOOR EMBLEM
*3 NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE *4 NO. 3 LUGGAGE COMPARTMENT DOOR NAME PLATE
● Non-reusable part - -
A01MAMJC03
*1 SIDE PANEL EMBLEM - -
● Non-reusable part - -

  1. SIDE PANEL EMBLEM

    A01MATSC03
    *a Location Pin

  2. NO. 3 LUGGAGE COMPARTMENT DOOR NAME PLATE

    A01MAIUC03
    *a Reference Values *b Radius End Point of Back Door
    *c 250.7 mm (9.87 in.) *d 102.9 mm (4.05 in.)
    *e 56.2 mm (2.21 in.) - -

  3. NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE

    A01MAL7C01
    *a Reference Values *b Radius End Point of Back Door
    *c 205 mm (8.07 in.) *d 35.4 mm (1.39 in.)
    *e 31.1 mm (1.22 in.) *f 12.7 mm (0.50 in.)

  4. BACK DOOR NAME PLATE

    A01MAHCC02
    *a Reference Values *b Radius End Point of Back Door
    *c 30.4 mm (1.20 in.) *d 12.5 mm (0.49 in.)
    *e 153.7 mm (6.05 in.) *f 13.7 mm (0.54 in.)
    *g 35.1 mm (1.38 in.) *h 4.2 mm (0.17 in.)

  5. LUGGAGE COMPARTMENT DOOR EMBLEM

    A01MATGC02
    *a Location Pin