FRONT FENDER APRON ASSEMBLY REPLACEMENT

A01IEBK


  1. REMOVAL

    Symbol Meaning
    B006JOY Remove Weld Points
    B006JNW Remove Weld Points
    B006JQU Remove Weld Points

    1. After removing the A, remove the front fender apron sub-assembly.

      Tech Tips

      A is reused.

      A01IE71C01
      *A LH - -
      *1 FRONT FENDER APRON SUB-ASSEMBLY - -
      A01IE8NC01
      *A LH - -

    2. After removing the A, remove the front fender apron sub-assembly.

      Tech Tips

      A is reused.

      A01IE88C01
      *A RH - -
      *1 FRONT FENDER APRON SUB-ASSEMBLY - -
      A01IE6FC01
      *A RH - -

  2. INSTALLATION

    Symbol Meaning
    B006JU9 Plug Weld
    B006JR6 Plug Weld
    B006JRV Plug Weld
    B006JSM Body Sealer

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.

    4. Before installing a new part, apply body sealer.

      Tech Tips

      Apply body sealer in an even, continuous bead.

      A01IE7LC01
      *A LH - -

    5. Weld the front fender apron sub-assembly to the vehicle side.

      A01IE5HC01
      *A LH - -
      *1 FRONT FENDER APRON SUB-ASSEMBLY - -
      A01IE9UC01
      *A LH - -

    6. Weld the A to the vehicle side.

      A01IEG0C01
      *A LH - -

    7. Before installing a new part, apply body sealer.

      Tech Tips

      Apply body sealer in an even, continuous bead.

      A01IEAMC01
      *A RH - -

    8. Weld the front fender apron sub-assembly to the vehicle side.

      A01IE8DC01
      *A RH - -
      *1 FRONT FENDER APRON SUB-ASSEMBLY - -
      A01IEC2C01
      *A RH - -

    9. Weld the A to the vehicle side.

      A01IEDCC01
      *A RH - -

    10. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)

    11. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.