Refer to the TOYOTA Repair Manual for each work procedure.
PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED
| Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed |
|---|---|
| Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and Start System (for 2AR-FE) |
| Stop and Start System (for 2GR-FKS) | |
| Memorize steering angle neutral point | Panoramic View Monitor System |
| Initialize back door lock | Power Door Lock Control System |
| Initialize servo motor | Air Conditioning System |
| Reset slide door close position | Power Slide Door System |
| Reset back door close position | Power Back Door System |
Note
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal. (Audio and Visual System (for Radio and Display Type))
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal. (Navigation System (for Radio and Display Type))
After the engine switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal. (Navigation System (for Navigation Receiver Type))