Refer to the TOYOTA Repair Manual for each work procedure.
PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED
| Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed |
|---|---|
| Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) | Stop and start system |
| Memorize steering angle neutral point | Panoramic view monitor system |
| Initialize back door lock | Power door lock control system |
| Initialize servo motor | Air conditioning system |
| Reset slide door close position | Power slide door system |
| Reset back door close position | Power back door system |
Note
After the engine switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation Receiver Type)
After the engine switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal. (for Radio and Display Type)