LUGGAGE DOOR(for Sliding roof) THREE-DIMENSIONAL DISTANCE
Tech Tips
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Roof Panel Corner | - |
| B, b | Quarter Panel Standard Hole | φ10 (0.39) |
| C | Upper Back Reinforcement Center Mark | - |
| D, d | Luggage Compartment Opening Trough Corner | - |
| E, e | Quarter Panel Extension Outer Corner | - |
| F, f | Quarter Panel Standard Hole | φ13 (0.51) |
| G, g | Rear Finish Plate Installation Hole | φ8.5 (0.33) |
| H, h | Luggage Door Lock Striker Installation Nut | M8 (0.31) |
| J, j | Rear Bumper Reinforcement Installation Nut | M8 (0.31) |
| K, k | Rear Floor Side Member Rear Standard Hole | φ18 (0.71) |
| L, l | Rear Spring Support Installation Hole | φ11 (0.43) |
| M | Center Floor Cross Member No.2 Standard Hole | φ13 (0.51) |
| N, n | Front Body Pillar Assembly Mark | - |
| *a | Distance between points other than those above | *b | mm (in.) |