BODY LOWER BACK PANEL ASSEMBLY REPLACEMENT

A01CSU4

  1. REMOVAL

    Symbol Meaning
    B002GA9 Remove Weld Points
    B002G8M Remove Weld Points
    A01CSLN
    A01CSUHC01
    *A LH Side *B RH Side

    1. Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

      Tech Tips

      In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.

      A01CSJBC01
      A01H2DV Adhesive - -

  2. INSTALLATION

    Symbol Meaning
    B002GBI Plug Weld
    B002GAP Plug Weld

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. Apply adhesive (3MTMAutomixTMPanel Bonding Adhesive #8115).

      Tech Tips


      • Apply a light coat of adhesive around the plug welding points.

      • Apply enough adhesive to the panels.

      A01CSJBC01
      A01H2DV Adhesive - -
      A01CSOFC01
      *1 BODY LOWER BACK PANEL SUB-ASSEMBLY - -
      A01CSJ8C01
      *A LH Side *B RH Side

    4. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.