UNDER BODY TWO-DIMENSIONAL DISTANCE

Tech Tips


  • Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

  • Point B, b, C, c, H, h, J, j, L, l on the vehicle are asymmetrical.

  • In cases in which only one dimension is given, left and right are symmetrical.

  • For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

Measuring Point Name
Symbol Name

Hole Diameter

mm (in.)
A, a Front Body Mounting Reinforcement Standard Hole φ13 (0.51)
B, b Front Cross Member Installation Nut M12 (0.47)
C, c Front Side Member Standard Hole φ18 (0.71)
D, d Front Suspension Crossmember Installation Nut M14 (0.55)
E, e Front Suspension Installation Hole φ12.5 (0.49)
F, f Front Suspension Crossmember Installation Nut M14 (0.55)
G, g Torque Box Front Standard Hole φ25 (0.98)
H, h Front Side Member Reinforcement Rear No.1 Standard Hole φ15 (0.98)
J, j Propeller Shaft Center Bearing Support Installation Nut M10 (0.39)
K, k Front Floor Under Reinforcement Standard Hole φ15 (0.59)
L, l Rear Floor Reinforcement No.3 Standard Hole φ18 (0.71)
M, m Rear Floor Side Member Front Standard Hole φ16 (0.63)
N, n Rear Suspension Crossmember Installation Nut M14 (0.55)
O, o Rear Suspension Crossmember Installation Nut M14 (0.55)
P, p Rear Floor Side Member Rear Standard Hole φ18 (0.71)
Wheel Base
Wheel Base 2660 mm (104.72 in.)
A01CSLUC01
*A FRONT *B LH
*C RH - -
*a

mm

(in.)

 - -
A01CSTAC01
*a Imaginary Datum Line *b Height from Imaginary Datum Line
*c

mm

(in.)

 - -