UNDER BODY THREE-DIMENSIONAL DISTANCE
Tech Tips
-
Point B, b, C, c, G, g, H, h, K, k on the vehicle are asymmetrical.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Front Body Mounting Reinforcement Standard Hole | φ13 (0.51) |
| B, b | Front Cross Member Installation Nut | M12 (0.47) |
| C, c | Front Side Member Standard Hole | φ18 (0.71) |
| D, d | Front Suspension Crossmember Installation Nut | M14 (0.55) |
| E, e | Front Suspension Crossmember Installation Nut | M14 (0.55) |
| F, f | Torque Box Front Standard Hole | φ25 (0.98) |
| G, g | Front Side Member Reinforcement Rear No.1 Standard Hole | φ15 (0.59) |
| H, h | Propeller Shaft Center Bearing Support Installation Nut | M10 (0.39) |
| J, j | Front Floor Under Reinforcement Standard Hole | φ15 (0.59) |
| K, k | Rear Floor Reinforcement No.3 Standard Hole | φ18 (0.71) |
| L, l | Rear Floor Side Member Front Standard Hole | φ16 (0.63) |
| M, m | Rear Suspension Crossmember Installation Nut | M14 (0.55) |
| N, n | Rear Suspension Crossmember Installation Nut | M14 (0.55) |
| O, o | Rear Floor Side Member Rear Standard Hole | φ18 (0.71) |
| *A | FRONT | *B | LH |
| *C | RH | - | - |
| *a | Distance between points other than those to the left | *b | mm (in.) |