NAME PLATE ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    Tech Tips

    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    Note

    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    Tech Tips

    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.

A018MKOC01
*1 NO. 1 BACK DOOR NAME PLATE *2 NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
*3 NO. 4 BACK DOOR NAME PLATE *4 NO. 4 LUGGAGE COMPARTMENT DOOR PLATE
*5 SYMBOL EMBLEM - -
● Non-reusable part - -

  1. INSTALL NO. 4 LUGGAGE COMPARTMENT DOOR PLATE

    A018MM2C01
    *a Edge of Curved Surface *b Profile of Back Door Panel

  2. INSTALL NO. 4 BACK DOOR NAME PLATE

    A018MLMC01
    3. *a Edge of Curved Surface *b Profile of Back Door Panel

  • INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE

    Figure 1. for HIGHLANDER Plate:

    A018MKKC01
    • *a Edge of Curved Surface *b Profile of Back Door Panel

    Figure 2. for KLUGER Plate:

    A018MOEC01
    *a Edge of Curved Surface *b Profile of Back Door Panel

  • INSTALL NO. 1 BACK DOOR NAME PLATE

    A018MOLC01
    • *a Edge of Curved Surface *b Profile of Back Door Panel