ROOF PANEL(for Sliding Roof) ASSEMBLY REPLACEMENT

A018MIE

  1. REMOVAL

    Symbol meaning
    A002667 Remove Weld Points
    A00265D Remove Weld Points

      REMOVAL POINT

    1. If reusing the roof panel reinforcement, trim the hemming location using a disc sander, etc.

    A018MI4C01
    *1 Disc Sander - -

  2. INSTALLATION

    Symbol meaning
    A018MJA Spot Weld
    A00266T Plug Weld
    A002652 Plug Weld
    A00265Q Body Sealer

      INSTALLATION POINT

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. Before temporarily installing the new parts, apply body sealer to the windshield header panel, roof panel reinforcement and back door opening frame.

      Tech Tips

      Apply just enough body sealer for the new parts to make contact.

    4. After the roof panel reinforcement is welded to the new parts, install the roof panel to the vehicle side.

    5. Bend the flange hem with a wooden hammer and dolly.

      Tech Tips

      Bend the panel gradually so as not to distort it.

    6. After welding, apply the foamed sealing material to the corresponding parts. (See the painting /coating)

    7. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    8. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A018MPO
    A018MM5C01
    *1 ROOF PANEL *2 Dolly
    *3 Cloth Tape *4 Wooden Hammer