REAR DOOR OUTER PANEL ASSEMBLY REPLACEMENT



  1. REMOVAL

    Symbol meaning
    A002667 Remove Weld Points

      REMOVAL POINT

    1. Before removing the outer panel, mark the installation position with tape.

    2. Before removing the outer panel, establish its exact position in relation to the window frame using a reference marker, etc.

    3. After grinding off the hemming location, remove the outer panel.

    A018MLOC01
    *1 Positioning Tape *2 Disc Sander
    *a Installation Postion *b Hemming Location

  2. INSTALLATION

    Symbol meaning
    A00266T Plug Weld
    A018MPG Spot MIG Weld
    A00265Q Body Sealer

      INSTALLATION POINT

    1. Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and backside of the new parts.

      Note

      Do not close the drain hole.

      Tech Tips

      Apply sealer evenly about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement and side impact protection beam to make contact.

    2. Bend the flange hem with a wooden hammer and dolly.

      Tech Tips

      Bend the panel gradually so as not to distort it.

    3. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    4. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A018MN1C01
    *1 Positioning Tape *2 REAR DOOR PANEL OUTER
    *3 Dolly *4 Cloth Tape
    *5 Wooden Hammer - -
    *a Drain hole *b mm (in.)