NAME PLATE ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    Tech Tips

    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    Note

    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    Tech Tips

    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.

A003JSNC01
*1 BACK DOOR ORNAMENT SUB-ASSEMBLY *2 NO. 1 BACK DOOR NAME PLATE
*3 NO. 2 BACK DOOR NAME PLATE - -
● Non-reusable part - -
A003JN3C01
*A for LH Side *B for RH Side
*1 SIDE PANEL EMBLEM - -
● Non-reusable part - -

  1. SIDE PANEL EMBLEM


    1. for LH Side:

      A003JUKC01

    2. for RH Side:

      A003JUEC01

    3. BACK DOOR ORNAMENT SUB-ASSEMBLY

      A003JR5

    4. NO. 2 BACK DOOR NAME PLATE

      A003JHSC01
      5. *a Edge of Curved Surface *b Profile of Back Door Panel

  • NO. 1 BACK DOOR NAME PLATE

    A003JI8C01
    • *a Edge of Curved Surface *b Profile of Back Door Panel