NAME PLATE ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    Tech Tips

    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    Note

    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    Tech Tips

    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.

A00WGMGE01
A00WGPZE01
A00WGKME01

  1. SYMBOL EMBLEM

    A00WGRHE01
    Text in Illustration
    *1 Boss

  2. NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE

    A00WGQGE01
    Text in Illustration
    *1 Application Sheet *2 Cut Line
    *3 Fold Line *4 Position Alignment Hole
    *5 Rear Light Assembly LH *6 Luggage Compartment Door Outside Garnish

  3. NO. 3 LUGGAGE COMPARTMENT DOOR NAME PLATE

    A00WGIOE01
    Text in Illustration
    *A for Standard Body *B for Long Body
    *1 Application Sheet *2 Cut Line
    *3 Fold Line *4 Position Alignment Hole
    *5 Rear Light Assembly RH *6 Luggage Compartment Door Outside Garnish

  4. NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE (for AWD)

    A00WGMHE01
    Text in Illustration
    *1 Outside Garnish End Line *2 Application Sheet
    *3 Perforation - -

  5. FRONT FENDER NO. 2 NAME PLATE

    A00WGGYE01
    Text in Illustration
    *1 Boss

  6. FRONT FENDER NO. 1 NAME PLATE

    A00WGR3E01
    Text in Illustration
    *1 Boss