CENTER BODY PILLAR (for Long Body) CUT AND JOIN REPLACEMENT SECTIONS

A00WGOF

  1. REMOVAL

    Symbol Meaning
    A00WGQT Remove Weld Points
    A00WGK6 Remove Weld Points
    A00WGP9 Cut with Disc Sander etc.
    A00WGN4 Cut and Join Location
    A00WGR4 Cut Location for Supply Parts

      REMOVAL POINT

    1. Reuse *1, as the area of the outer panel that is cut and joined is to the rear of the supplied part cut position.

    2. *2 is reused.

    3. *3 indicates the location of the foamed sealing material. Be careful when cutting as the foamed sealing material is located near the cutting position.

    A00WGP4E01
    A00WGNJE01

  2. INSTALLATION

    Symbol Meaning
    A00WGPW Spot Weld
    A00WGHS Plug Weld
    A00WGPL Plug Weld
    A00WGN4 Cut and Join Location
    A00WGPK Fillet Weld
    A00WGII Butt Weld

      INSTALLATION POINT

    1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

    3. If the entire supply part is not needed, remove the part of the supply part that is needed.

    4. Before temporarily installing the new parts, weld the rocker panel reinforcement sub-assembly, center body pillar reinforcement sub-assembly and center body pillar sub-assembly inner with the standard number of welding points.

    5. *1 indicates the location of the foamed sealing material. Be careful when welding as the foamed sealing material is located near the area that is cut and joined together.

    6. After welding the rocker panel reinforcement sub-assembly, center body pillar reinforcement sub-assembly and center body pillar sub-assembly inner to the vehicle side, install the center body pillar outer, *2 and *3.

    7. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)

    8. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    9. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A00WGJ6E01
    A00WGPCE01
    A00WGQAE01