Click here

ROOF WINDOW FIX GLASS INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL NO. 6 SUNSHADE TRIM PROTECTOR


    1. A01IO9Y

      Install the sunshade trim protector.

  2. Click here

    INSTALL NO. 2 SLIDING ROOF SEAL


    1. Clean the No. 1 roof window glass where the No. 2 sliding roof seal will be installed.

    2. Apply Primer M to the No. 1 roof window glass where the No. 2 sliding roof seal will be installed.

      Note:

      Do not apply too much primer.

    3. Remove the peeling paper from a new No. 2 sliding roof seal.

    4. A01IOAEE01

      Install the No. 2 sliding roof seal as shown in the illustration.

      Table 1. Text in Illustration
      *1 No. 2 Sliding Roof Seal *2 Make sure there is no gap
      Note:

      • Wait until the primer is dry (approximately 3 minutes) before installing the No. 2 sliding roof seal.

      • Make sure the No. 2 sliding roof seal is securely installed to prevent water leakage.

  3. Click here

    INSTALL NO. 1 ROOF WINDOW GLASS SUB-ASSEMBLY


    1. A01IURXE02

      Set the No. 1 roof window glass on the vehicle while being careful of the guide pins and windshield outside moulding as shown in the illustration.

      Table 2. Text in Illustration
      *1 Roof Window Glass Sub-assembly RH *2 Windshield Outside Moulding
      *3 Body *4 Guide Pin
      Note:

      • If the No. 1 roof window glass is not as shown in the illustration, remove it and set it on the vehicle again.

      • If shims are present, do not remove or adjust them.

    2. A01ISG7E02

      Install the roof window glass with the 24 nuts.

      for nut A
      9.1 N*m 93 kgf*cm 81 in.*lbf
      for nut B
      4.0 N*m 41 kgf*cm 35 in.*lbf
  4. Click here

    CHECK FOR LEAK


    1. Adjust the roof window glass and check for water leaks.

      If there are any leaks, readjust the roof window glass.

  5. Click here

    INSTALL ROOF HEADLINING ASSEMBLY


    1. Install the roof headlining assembly (Click here).