ROOF WINDOW FIX GLASS INSTALLATION


  1. INSTALL NO. 6 SUNSHADE TRIM PROTECTOR


    1. A01IO9Y

      Install the sunshade trim protector.

  2. INSTALL NO. 2 SLIDING ROOF SEAL


    1. Clean the No. 1 roof window glass where the No. 2 sliding roof seal will be installed.

    2. Apply Primer M to the No. 1 roof window glass where the No. 2 sliding roof seal will be installed.

      Note

      Do not apply too much primer.

    3. Remove the peeling paper from a new No. 2 sliding roof seal.

    4. Install the No. 2 sliding roof seal as shown in the illustration.

      A01IOAEE01
      Text in Illustration
      *1 No. 2 Sliding Roof Seal *2 Make sure there is no gap

      Note


      • Wait until the primer is dry (approximately 3 minutes) before installing the No. 2 sliding roof seal.

      • Make sure the No. 2 sliding roof seal is securely installed to prevent water leakage.

  3. INSTALL NO. 1 ROOF WINDOW GLASS SUB-ASSEMBLY


    1. Set the No. 1 roof window glass on the vehicle while being careful of the guide pins and windshield outside moulding as shown in the illustration.

      A01IURXE02
      Text in Illustration
      *1 Roof Window Glass Sub-assembly RH *2 Windshield Outside Moulding
      *3 Body *4 Guide Pin

      Note


      • If the No. 1 roof window glass is not as shown in the illustration, remove it and set it on the vehicle again.

      • If shims are present, do not remove or adjust them.

    2. Install the roof window glass with the 24 nuts.

      A01ISG7E02
      Torque:
      for nut A
      9.1 N*m  { 93 kgf*cm, 81 in.*lbf }
      for nut B
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

  4. CHECK FOR LEAK


    1. Adjust the roof window glass and check for water leaks.

      If there are any leaks, readjust the roof window glass.

  5. INSTALL ROOF HEADLINING ASSEMBLY


    1. Install the roof headlining assembly Click here.