FRONT SIDE FIX WINDOW GLASS INSTALLATION

INSTALL FRONT SIDE FIX WINDOW ASSEMBLY LH

1. 

   Text in Illustration

   *1	CORRECT
   *2	Primer M
   *3	Adhesive
   *4	INCORRECT

   Using a brush, apply Primer M to the exposed part of the vehicle body.

   Note

   
   

   • Allow the primer to dry for 3 minutes or more.

   • Do not apply primer to the adhesive.

   • Throw away any leftover primer.

   • Do not apply too much primer.

2. Using a brush or sponge, apply Primer G to the contact surface of the window.

   

   Text in Illustration

   *1	Backside	*2	Adhesive Center Line
   *3	Primer G	-	-

   Tech Tips

   If the primer is applied to an area that is not specified, apply non-residue solvent to a clean cloth and wipe off the excess primer.

   Note

   
   

   • Allow the primer to dry for 3 minutes or more.

   • Throw away any leftover primer.

   • Do not apply too much primer.

3. Apply adhesive to the window.

   

   Text in Illustration

   *1	Backside	*2	Adhesive Center Line
   *3	Adhesive	-	-

   Adhesive
   Toyota Genuine Windshield Glass Adhesive or equivalent

   
   

   1. Cut off the tip of the cartridge nozzle as shown in the illustration.

      Tech Tips

      After cutting off the tip, use all adhesive within the time written in the table below.

      Usage Time Frame
      Temperature Usage Time Frame 35°C (95°F) 15 minutes 20°C (68°F) 1 hour 40 minutes 5°C (41°F) 8 hours

   2. Load the sealer gun with the cartridge.

   3. Apply adhesive to the window as shown in the illustration.

      Standard
      Area Specified Condition a 8.0 mm (0.315 in.) b 6.0 mm (0.236 in.)

4. Install the front side fix window to the vehicle body.

   
   

   1. Attach the 3 clips to install the front side fix window.

   2. Lightly press the outer surface of the window to ensure that the window is securely fit to the vehicle body.

      Note

      
      

      • Check that the 3 clips are attached to the vehicle body correctly.

      • Check that the vehicle body and window have a small gap between them.

   3. Using a scraper, remove any excess or protruding adhesive.

      Tech Tips

      Apply adhesive to any areas where the amount of adhesive is inadequate.

   4. Hold the front side fix window in place securely with protective tape or equivalent until the adhesive hardens.

      Note

      Do not drive the vehicle for the amount of time written in the table below.

      Minimum Time
      Temperature Minimum Time Prior to Driving Vehicle 35°C (95°F) 1 hour 30 minutes 20°C (68°F) 5 hours 5°C (41°F) 24 hours

CHECK FOR LEAKS AND REPAIR

1. Conduct a leak test after the adhesive has completely hardened.

2. If there are any leaks, seal them with auto glass sealer.