ROOF SUNSHADE SYSTEM Power Source Circuit

DESCRIPTION

If the sliding function does not operate, there may be a malfunction in the sliding roof drive gear power source circuit.

WIRING DIAGRAM

A01IT2FE05

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY - BATTERY AND BODY GROUND)


    1. A01ISJ0E02
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Sliding Roof Drive Gear)

      Disconnect the z3 sliding roof drive gear connector.

    2. Measure the resistance and voltage according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      z3-2 - Body ground Always Below 1 Ω
      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      z3-1 - Body ground Always 11 to 14 V
      z3-5 - Body ground Ignition switch off Below 1 V
      z3-5 - Body ground Ignition switch ON 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY Click here