HEATER FUEL PUMP (w/ Combustion Type Power Heater) REMOVAL


  1. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE FRONT WIPER ARM HEAD CAP


    1. A01IRPA

      Using a screwdriver, remove the front wiper arm head cap.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for all front wiper arm head caps.

  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A01INFE

      Remove the nut and front wiper arm and blade assembly LH.

  4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    1. A01IT06

      Remove the nut and front wiper arm and blade assembly RH.

  5. REMOVE HOOD TO COWL TOP SEAL


    1. A01IQHZ

      Using a clip remover, detach the 7 clips and 2 claws, and remove the hood to cowl top seal.

  6. REMOVE COWL TOP VENTILATOR LOUVER LH


    1. A01INVH

      Detach the 2 claws and 2 guides, and remove the center cowl top ventilator louver.

    2. A01ISIY

      Remove the clip.

    3. Detach the 6 claws and 5 guides, and remove the cowl top ventilator louver LH.

  7. REMOVE COWL TOP VENTILATOR LOUVER RH


    1. A01IUL4

      Remove the clip.

    2. Detach the 4 claws and 5 guides, and remove the cowl top ventilator louver RH.

  8. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    1. A01IQJZ

      Disconnect the connector. Then detach the clamp and remove the wire harness from the cowl top panel.

    2. A01ITHG

      Remove the 2 bolts.

    3. A01IO76

      Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body and remove the wiper motor and link.

  9. REMOVE DIFFERENTIAL PRESSURE SENSOR ASSEMBLY (for DPF)


    1. A01ISZQ

      Detach the wire harness clamp and disconnect the sensor connector.

    2. Remove the bolt and sensor.

    3. Disconnect the 2 vacuum hoses.

  10. REMOVE COWL TOP OUTER PANEL


    1. A01IO5B

      Remove the 9 bolts and outer cowl top panel.

  11. REMOVE HEATER PUMP ASSEMBLY


    1. Disconnect the connector.

    2. Using pliers, grip the claws of the clips, slide the 2 clips and disconnect the 2 fuel hoses.

    3. Remove the nut and heater pump assembly.

      A01IUAV