ROOM TEMPERATURE SENSOR (for Automatic Air Conditioning System) REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01IR0Y

    1. Remove the 2 screws <A>.

    2. Detach the claw and guide, and remove the No. 1 instrument panel under cover.

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. A01IP8D

      Remove the 4 bolts.

    2. Detach the 6 claws and remove the instrument panel airbag.

    3. Disconnect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  5. REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)

    A01IQOO

    1. Disconnect the connector.

    2. Disconnect the hose, detach the 2 claws and remove the sensor.