CONDENSER (for AD Series Engine) REMOVAL


  1. REMOVE FRONT BUMPER COVER


    1. Remove the front bumper cover Click here.

  2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


    1. Start the engine.

    2. Turn the A/C switch on.

    3. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

    4. Stop the engine.

    5. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

  3. REMOVE OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)


    1. A01ISAV

      Remove the 3 bolts, nut and oil cooler assembly.

  4. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    1. A01IUGE

      Remove the bolt and disconnect the discharge hose sub-assembly from the condenser.

    2. Remove the O-ring from the discharge hose sub-assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  5. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY


    1. A01IQ6T

      Remove the bolt and disconnect the air conditioning tube and accessory assembly from the condenser.

    2. Remove the O-ring from the air conditioning tube and accessory assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  6. REMOVE UPPER RADIATOR SUPPORT


    1. A01IR1CE01
      Text in Illustration
      *A w/o Air Cooled Transmission Oil Cooler
      *B w/ Air Cooled Transmission Oil Cooler

      Remove the 2 bolts and 2 upper radiator supports.

    2. Remove the 2 radiator support cushions.

  7. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY LH


    1. A01IUDD

      Remove the 2 bolts and upper radiator support sub-assembly LH.

  8. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY RH


    1. Detach the clamp.

    2. A01ITLA

      Remove the 2 bolts and upper radiator support sub-assembly RH.

  9. REMOVE CONDENSER ASSEMBLY WITH RECEIVER


    1. A01IREB

      Remove the condenser assembly with receiver as shown in the illustration.