AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) Generator Signal Circuit

Click here

DESCRIPTION

When the engine is started, the generator assembly turns on and a pulsed voltage signal is generated.

This signal is used by the air conditioning amplifier assembly.

The signal expressing the amount of output from the generator assembly is one element of PTC heater control.

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE

1. Click here

   CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - GENERATOR)

   
   
   1. 

      Disconnect the H46 amplifier connector.

   2. Disconnect the C26 generator connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition H46-25 (ALT) - C26-3 (M) Always Below 1 Ω H46-25 (ALT) - Body ground Always 10 kΩ or higher

      Table 1. Text in Illustration

      *1	Rear view of wire harness connector (to Air Conditioning Amplifier Assembly)
      *2	Front view of wire harness connector (to Generator Assembly)

   
   
   • OKClick here
   • NGClick here
2. Click here

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

3. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR