FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE LH

    A01IPG9

    1. Detach the 8 claws and 2 clips, and remove the front door scuff plate.

  4. REMOVE COWL SIDE TRIM BOARD LH

    A01ISRD

    1. Detach the 2 clips and guide, and remove the cowl side trim board.

  5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    A01INM0

    1. Remove the front door opening trim weatherstrip.

  6. REMOVE REAR DOOR SCUFF PLATE LH

    A01IQ4G

    1. Detach the 9 claws and 2 clips, and remove the rear door scuff plate.

  7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    A01ISHX

    1. Remove the rear door opening trim weatherstrip.

  8. REMOVE LOWER CENTER PILLAR GARNISH LH

    A01IUA8

    1. Detach the 2 claws and 2 clips, and remove the lower center pillar garnish.

  9. REMOVE NO. 2 FLOOR BOARD


    1. Remove the No. 2 floor board.

  10. REMOVE LAP BELT OUTER ANCHOR COVER

    A01IOX0

    Tech Tips

    Use the same procedure for the other lap belt outer anchor cover.


    1. Detach the 3 claws and remove the lap belt outer anchor cover.

  11. REMOVE CENTER PILLAR GARNISH LH

    A01IS1B

    1. Remove the bolt and disconnect the front seat outer belt floor anchor.

    2. A01IO55

      Remove the 2 screws.

    3. Detach the clip.

    4. Pass the front seat outer belt floor anchor through the center pillar garnish, and remove the center pillar garnish.

  12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

    A01IP9M

    1. Remove the nut and shoulder anchor.

    2. A01IRGN

      Disconnect the pretensioner connector as shown in the illustration.

    3. A01IN1P

      Remove the 2 bolts and front seat outer belt.

  13. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A01INZ2

      Remove the 2 bolts and anchor adjuster.