OCCUPANT DETECTION SENSOR REASSEMBLY

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


  1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR)


    1. A01IQ2EE01
      Text in Illustration
      *1 Hog Ring Pliers

      Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with new hog rings.

      Note


      • Be careful not to damage the cover.

      • When installing the hog rings, avoid wrinkling the cover.

  2. INSTALL SEAT CUSHION COVER WITH PAD

    A01INQP

    1. Set the seat cushion cover with pad in place.

    2. Attach the hooks to install the seat cushion cover with pad.

    3. A01ITSBE02
      Text in Illustration
      *A w/ Seat Heater System
      *1 Wire Harness Clamp
      *2 Hook

      Attach the 3 hooks and wire harness clamp.

    4. w/ Seat Heater System:


      1. Connect the connector.

      2. A01IRLA

        Attach the 3 wire harness clamps.

    5. A01IOAP

      for Passenger Side:

      Attach the 2 hooks to connect the connector holder.

    6. A01IT5VE01
      Text in Illustration
      *1 Fastening Tape
      *2 Airbag Wire Harness

      Attach the piece of fastening tape to connect the airbag wire harness.

  3. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH


    1. A01ISO3E01
      Text in Illustration
      *1 Protruding Part

      Install the front seat inner belt with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.

    2. for Driver Side:

      Connect the connector and attach the clamps.

    3. for Passenger Side:

      Connect the connectors and attach the clamps.

    4. A01IOL2

      Close the seatback cover and attach the 2 hooks as shown in the as illustration.

  4. INSTALL FRONT SEAT UNDER TRAY (w/ Under Tray)


    1. A01IOQH

      Attach the 2 hooks to install the front seat under tray.

  5. INSTALL FRONT SEAT INNER CUSHION SHIELD RH


    1. A01IRB9E01
      Text in Illustration
      *1 Wire Harness Clamp
      *2 Hook

      Attach the wire harness clamp.

    2. Slide the front seat inner cushion shield LH to attach the hook.

    3. A01IT7C

      Push the front seat inner cushion shield LH to attach the hook and claw.

    4. Install the front seat inner cushion shield with the screw.

  6. INSTALL FRONT SEAT CUSHION SHIELD RH


    1. A01INSK

      Slide the front seat cushion shield LH to attach the 2 hooks.

      Text in Illustration
      A01ISER Slide
      A01ISM9 Push

    2. Push the front seat cushion shield LH to attach the claw.

    3. Install the front seat cushion shield LH with the 2 screws.

    4. A01IQQC

      Attach the 2 hooks to connect the 2 rubber bands.

  7. INSTALL RECLINING ADJUSTER RELEASE HANDLE RH


    1. A01ITUL

      Attach the claw to install the reclining adjuster release handle LH.