OCCUPANT DETECTION SENSOR DISASSEMBLY

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


  1. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH


    1. A01IPYYE01
      Text in Illustration
      *1 Protective Tape

      Raise the reclining adjuster release handle LH to reveal the claw. Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE FRONT SEAT CUSHION SHIELD RH


    1. A01IP89

      Detach the 2 hooks and disconnect the 2 rubber bands.

    2. A01IRWW

      Remove the 2 screws.

    3. Pull the front seat cushion shield LH to detach the claw.

      Text in Illustration
      A01ISM9 Pull
      A01ISER Slide

    4. Slide the front seat cushion shield LH to detach the 2 hooks and remove the front seat cushion shield LH.

  3. REMOVE FRONT SEAT INNER CUSHION SHIELD RH


    1. A01INHB

      Remove the screw.

    2. Pull the front seat inner cushion shield LH to detach the hook and claw.

    3. A01IOSLE01
      Text in Illustration
      *1 Wire Harness Clamp
      *2 Hook

      Slide the front seat inner cushion shield LH to detach the hook and remove the front seat inner cushion shield LH.

    4. Detach the wire harness clamp.

  4. REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)


    1. A01IRKR

      Detach the 2 hooks and remove the front seat under tray.

  5. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH

    A01IOVY

    1. Detach the 2 hooks and open the seatback cover as shown in the illustration.

    2. for Driver Side:

      Disconnect the connector and detach the clamps.

    3. for Passenger Side:

      Disconnect the connectors and detach the clamps.

    4. A01IORF

      Remove the nut and front seat inner belt.

  6. REMOVE SEAT CUSHION COVER WITH PAD


    1. A01IT5VE01
      Text in Illustration
      *1 Fastening Tape
      *2 Airbag Wire Harness

      Detach the piece of fastening tape and disconnect the airbag wire harness from the seat cushion cover with pad.

    2. A01IOAP

      for Passenger Side:

      Detach the 2 hooks and disconnect the connector holder.

    3. w/ Seat Heater System:


      1. A01IRLA

        Detach the 3 wire harness clamps.

      2. A01ITSBE01

        Disconnect the connector.

    4. Detach the wire harness clamp and 3 hooks.

      Text in Illustration
      *1 Wire Harness Clamp
      *2 Hook
    5. A01INQP

      Detach the hooks and remove the seat cushion cover with pad.

  7. REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR)


    1. A01IOE6

      Remove the hog rings and separate type front seat cushion pad from the separate type front seat cushion cover.