FRONT SEAT ASSEMBLY REMOVAL

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT SEAT HEADREST ASSEMBLY


    1. Remove the front seat headrest assembly.

  4. REMOVE FRONT SEAT OUTER TRACK BRACKET COVER LH


    1. Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.

    2. A01IUEG

      Detach the 5 claws and remove the front seat outer track bracket cover LH.

  5. REMOVE OUTER SEAT TRACK COVER LH


    1. Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.

    2. A01IQTF

      Detach the claw and remove the outer seat track cover LH.

  6. REMOVE INNER SEAT TRACK BRACKET COVER LH


    1. A01IPDP

      Detach the 2 claws and remove the inner seat track bracket cover LH.

  7. REMOVE NO. 2 FLOOR BOARD


    1. A01INCW

      Pull the strap and remove the No. 2 floor board.

  8. REMOVE FRONT NO. 2 FLOOR PAD


    1. A01IR2B

      Remove the front No. 2 floor pad.

  9. REMOVE FRONT SEAT ASSEMBLY


    1. A01IPH5

      Remove the 2 bolts.

    2. Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.

    3. A01IRHN

      Remove the 2 bolts.

    4. Lift up the seat track adjusting handle and move the front seat assembly to the center position. Also, operate the reclining adjuster release handle and move the front seatback to the upright position.

    5. Disconnect the connectors under the front seat assembly.

    6. Remove the front seat assembly from the vehicle.

      Note

      Be careful not to damage the vehicle body.