REAR CENTER SEAT ASSEMBLY (for Rear No. 1 Seat) INSTALLATION

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


  1. INSTALL REAR CENTER SEAT ASSEMBLY


    1. A01IP1K

      Place the rear center seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body or rear No. 1 seat assembly.

    2. Temporarily install the 2 bolts.

    3. Operate the rear center back lock control lever and raise the seatback.

    4. Lift up the seat track adjusting handle and move the seat to the foremost position.

    5. A01IQXJ

      Temporarily install the 2 bolts.

    6. A01ITEVE01

      Tighten the 4 bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    7. A01IRZR

      Connect the connector.

    8. Attach the wire harness clamp by attaching the 2 claws.

    9. A01IPWN

      Operate the rear back lock control lever RH and raise the rear No. 1 seatback LH.

  2. INSTALL REAR SEAT INNER TRACK BRACKET COVER LH


    1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    2. A01IRIK

      Attach the guide and 3 claws to install the cover.

  3. INSTALL REAR SEAT INNER TRACK BRACKET COVER RH

    Tech Tips

    Use the same procedures described for the LH side.

  4. INSTALL INNER SEAT TRACK BRACKET COVER LH


    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. A01IS2N

      Attach the 3 guides and 2 claws to install the cover.

  5. INSTALL INNER SEAT TRACK BRACKET COVER RH

    Tech Tips

    Use the same procedures described for the LH side.